Bevel Gear-Dynamic Simulation-Autodesk Inventor 2012 (with caption and audio narration)

 

Serial No. 5

Bevel Gear-Dynamic Simulation-Autodesk Inventor 2012 (with caption and audio narration)

 

Click the following link to get the model file:-  http://bit.ly/2m1eLaM

 

 Transcription of Video

1. Create a ‘New Assembly’ and save it with the name ‘Bevel Gear–Dynamic Simulation’.
2. Select Place component from the marking menu and place the Bevel Gear in the Assembly.
3. Align the Gear in correct position by using View Cube.
4. Select the Gear in the Design window, right click and deselect Grounded from the context menu.
5. At present there are six Degrees of Freedom in Gear and it can be moved in any direction in the Assembly.
6. Open the visibility of Z Axis of Assembly and Z Axis of Gear from the Browser Bar and then apply a Mate Constraint between them.
7. Apply another Mate Constraint between Centre point of the Assembly and Top point of the Gear.
8. Now this time only one Degrees of Freedom is left and Gear can be moved only on its Z Axis.
9. Select Place component from the marking menu and place the Pinion in the Assembly.
10. Open the visibility of Y Axis of Assembly and Z Axis of Pinion from the Browser Bar and then apply a Mate Constraint between them.
11. Apply a Mate Constraint between Top Point of Assembly and Centre Point of Pinion from the Browser Bar.
12. Activate the Motion Constraint, first select the top face of Pinion and then top face of Gear. In the Ratio input box, enter the value 23/57 and click Ok.
13. Set the browser from Assembly View to Modeling View using the toggle at the top of the browser.
14. Open the visibility of Pitch Diameter of Gear and Pitch Diameter of Pinion.
15. Once again, check the Degrees of Freedom of gear and pinion in the assembly, this time both the gears are rotating on their own Axis.
16. Activate the Dynamic Simulation Tool from the Begin Panel of Environments Tab.
17. Activate Insert Joint from the Marking menu.
18. Select ‘Rolling: Cone on Cone’ from the drop down menu of Insert Joint dialog box.
19. In the Insert Joint dialog box, select Pitch Diameter of Pinion in Component 1 and select Pitch Diameter of Gear in Component 2. Click Ok.
20. Select Revolution:2 joint in the Browser under the Standard Joints folder, right click and select Properties from the context menu.
21. Click dof 1 (R) tab and select Edit imposed motion button and check the Enable imposed motion option.
22. Click the arrow to expand the input choices, and click Constant Value.
23. Enter the value 360 deg/s and click Ok.
24. Close the visibility of Pitch diameter of Bevel Gear and Pinion.
25. In Simulation Player fill the value 1000 in the Images field area.
26. Clear the screen by activating the Clean Screen command.
27. Click Run in the Simulation Player to display motion in Bevel Gear and Pinion.