Friday, April 21, 2017

Animation of ‘Bolt and Nut’ || Using Creo Mechanism

Animation-of-Hinge--Using-Creo-Mechanism

This PTC Creo 3.0 tutorial will show how to animate the assembly of ‘Bolt and Nut’ using the Creo Mechanism application. This application is used to move and analyze the motion of a Mechanism.


First, we will place the Bolt part in the assembly and assemble it at default location. Next, we will place the Bolt part and a pre-defined constraint set ‘Cylinder’ will be applied which provides two-axis joints, Translation and Rotation. Later we will apply two Servo Motors on both axes to run the Nut over the Bolt like a screw mechanism. 


The Pitch used in creating the Bolt and Nut is 0.05 (1/20) inch. That is why one servo motor will run at a velocity of 360°/second that will provide rotating motion and second servo motor will run at a velocity of 0.05 inch/second which will provide translation motion. When we run the Dynamic Analysis for 20 seconds the Nut will travel 1-inch distance over the Bolt.

By watching this tutorial viewers will observe as well as learn the following tools/commands of the software:--

  1. Placing components in assembly.
  2. Applying component references to fully constrained components
  3. Using pre-defined constraint set which are used for creating mechanism.
  4. Using Creo Mechanism Application.
  5. Inserting Servo Motor.
  6. Dynamic Analysis of Mechanism.
  7. Using Playback command which is used to replay the previously run analysis.

Note:--
………………..

To understand the video easily, focus over places where we have paused our mouse. This is done so as the viewers can easily read the command instructions/tooltips generated by the software and understand what is being done and why.
.............................

download-Link

 

Visit the following link to get files to complete the tutorial and the finished file …http://bit.ly/2MGnqdx

 


....................................................................................

Visit the following link to watch basic tutorial on Creo Parametric by me

https://www.youtube.com/playlist?list=PLhloyISzAQksnPmtyZtncWCQJ3NpoX_SW

.........................................................................

To watch detailed tutorials on the same software visit the following link:--

https://www.youtube.com/playlist?list=PLKWX3xUP3pPorULULn8Q5BbDXqBjK_ZXD

..........................................................................................

Hope all of you will enjoyed the tutorial. If you find the video useful please like it and share it with your friends/colleagues and do not forget to subscribe us to get latest updates about our new uploads.

http://www.youtube.com/user/nisheethsorjm?sub_confirmation=1

No comments:

Post a Comment