Application of 3D sketch with loft feature-Autodesk Inventor 2012 (with caption and audio narration)

 

Serial No. 145

Application of 3D sketch with loft feature-Autodesk Inventor 2012 (with caption and audio narration)

In this video, we will describe 3D sketch and its application in the creation of loft feature.

 

Click the following link to get the drawing sheet of the model: http://bit.ly/2m51dLC

 

 

 Transcription of Video

Application of 3D sketch with loft feature

In this video we will describe about 3D sketch and its application in creation of loft feature.

1. This is our sketch which is named Sketch5 in the browser.
2. It is 2 inch up vertically from this point.
3. This sketch is placed on the Work Plane5.
4. Work Plane5 is 4.5 inch away from the Work Plane4.
5. Now we want to connect Sketch5 to the cup of the Spoon like this.
6. For this we will create two 3D sketches.
7. Start a 3D sketch from the Sketch panel of the Model Tab.
8. Create 3D line and close the sketch like this.
9. Once again create another 3D sketch in the same manner.
10. So the required two 3D sketches are in hand which we will use for developing the handle of Spoon.
11. Now pick up the loft tool from the Create panel of the Model Tab and develop the handle of Spoon like this.